BRING SHIP FROM DEAD CONDITION TO LIVE CONDITION

BRING SHIP FROM DEAD CONDITION TO LIVE CONDITION

1. DEAD SHIP CONDITION
2. SHORE SUPPLY AVAILABLE ESTABLISH SHORE SUPPLY. CHECK PHASE SEQUENCE, VOLTAGE AND FREQUENCY.	2. NO SHORE SUPPLY AVAILABLE ENSURE EMERGENCY GENERATOR DO TANK LEVEL IS ADEQUATE
3. SUPPLY MAIN SWITCHBOARD	3. START EMERGENCY GENERATOR
4. (a) ISOLATE SEQUENTIAL RESTART SYSTEM     (b) ALL ANCILLARY EQUIPMENT SET MANUAL TO AVOID     (c) LOW-PRESSURE AUTO START     (d) SUPPLY 440V, 220V EMERGENCY SWITCHBOARD
5. PREPARE CENTRAL FW COOLING SYSTEM, START CENTRAL COOLING WATER                            PUMP.
6. START GENERATOR LUB OIL PRIMING PUMP
7. START AIR COMPRESSOR AND TOP UP AIR RESERVOIR
8. START DO FLUSHING PUMP
9. (a) PREPARE DIESEL GENERATOR TO START     (b) START DIESEL GENERATOR
10. (a) PREPARE SW COOLING SYSTEM       (b) START SW COOLING SYSTEM
11. (a) DISCONNECT SHORE SUPPLY       (b) SUPPLY POWER TO 220V & 440V MAIN SWITCHBOARD       (c) SUPPLY POWER TO 220V & 440V EMERGENCY SWITCHBOARD
12. START UP CONTROL AIR SYSTEM
13. PLACE EMERGENCY GENERATOR ON STANDBY
14. RESET PREFERENTIAL TRIPS
15. (a) START E/R & ACCOMMODATION VENTILATION FANS.       (b) START AIR CONDITIONING PLANT.
16. ENSURE CO2 SYSTEM IS READY TO USE
17. (a) PUT WATER FOG SYSTEM IN OPERATION       (b) PRESSURISE MAIN FIRE LINE
18. START DOMESTIC FW SYSTEM WITH ELECTRIC HEATER IN USE
19. PUT DOMESTIC REFRIGERATION SYSTEM INTO OPERATION
20. PUT GENERAL SERVICE AIR SYSTEM INTO OPERATION
21. PUMP BILGES TO BILGE TANK AS REQUIRED
22. (a) PUT ALL ANCILLARY EQUIPMENT ON STANDBY       (b) RESTORE SEQUENTIAL RESTART SYSTEM       (c) PUT REMAINING DIESEL GENERATORS ON STANDBY
23.  PLANT IS NOW IN LIVE CONDITION